Looking for cabinet door.

[c_amos]

Does anyone have an old cabinet door laying around?

  I am looking for the one that goes on the cabinet with the drawers on the port side.

  I know many have re-designed thier interior and might have this part left over.  I am sure I can make something that might be close to the original but lack access to the tools I would choose, and doubt what ever I came up with would really look like the original.

  Please check your junk piles and let me know, thanks.  

[ebb]

What I took out of 338 is a solid mahogany plank with a inside rabbet around like you find on plywood doors in 60's kitchens.   You lookin for this?  

It is NOT a nice frame with louvers and a bronze cabinet latch.

It is 28" X 10 5/8" with 1/2" rabbets and an unlined finger hole.   The wood does have nice figure and is in good condition,  except for a SLIGHT warp you might expect in a solid piece.   The belly is out,  so it actually would look great hanging in the hole.  Originally mounted with particularly ugly surface mount offset hinges.

[c_amos]

28" X 10 5/8" with 1/2" rabbets and an unlined finger hole.

  That sounds close, like the hanging locker door.  I need to measure the door I am refering to, but the width seems right at about ~10 - 11" but I am thinking the height is more like ~12-13".

  I could probably just cut that down, and route the edge?  Might you be willing to part with this treasure?  

  Oh yea, I would also be interested in the;

   

particularly ugly surface mount offset hinges.

 

[ebb]

10.5" long - 11" wide.   Hinges on the short side.   Needs sanding and stuff.  Same as above w/ finger hole that doubles as a vent.

The two doors do not match in figure.   But are 'honduras' mahogany original. you betcha.

[c_amos]

If you PM me a figure (name your price, hopefully less then a million $$$), and an Email address i would greatly desire these fine exotic treasures.  Of course I will be interested in the original

particularly ugly surface mount offset hinges.

and even the latches (like a screw and socket) if you have them laying around.  

[ebb]

Easier to do "private messages"
Go to 'Members List' above here
Find ebb and send a private message to him on this site.
Please tell ebb your UPS shipping address plus a phone # I can put on the form.   Not to worry about the $, ok?

I thought you just needed the small one?
Just in case the piece is not what you expect,  I would rather  ship the one you really need first.    And it's in the box already.

The hinges are on the piece.   They are not really inset enough.   3/8s inset hinges would probably be better and they are the readily available ones.   The inset is 1/4" - however these hinges are unique and have an artdeco flavor to them.

Unless you get right back, you missed today, I think.

[c_amos]

Returned from a week on the road to find a pacakge on the door.

  Yes, it is exactly what I was looking for.  

Thank you, and know that part of 338 will soon be living aboard 226.

[ebb]

Yerwelcom,
Do you want the longer door?