ARIEL # 50 REVIVAL

[Bill]

Frank works on his boat in a very friendly yacht as this sign attests . . .

[Bill]

Remember those earlier photos of REVIVAL?  Well, here is what Frank found on the inside  

[Bill]

And, what it looked like as he removed all the stuff.  Note the pile in the cockpit.  Must be something there he can sell on eBay!

[Bill]

As I get to post these photos, we shall begin by examining some intersting technology . . . an engineer's delight . . . The head  :eek:

[Bill]

And, check out these pipes !  Frank says that there are four 1-1/2" and one 1-2/3" hoses going up to the deck -- and four (4) Y valves!   :eek:  :eek:   Maybe Frank will tell us all how this works . . . :confused:

[frank durant]

Bill .. if I could tell you how all that worked I would have needed to graduate from Harvard. The guy who installed it must have just bought shares in the hose manufacturing company.....or possibly the company making the plastic 'ties'. There was honestly OVER 60ft of hose total and had to be 100 ties !!! While I have NO doubt this system could ' slice,dice and do julian french fries ' I just couldn't figure it out. All joking aside , you could pump head to tank , head over board and tank overboard......I just couldn't find the instructions. The big attraction to the Ariel was the pleasing lines and simplicity of sailing a small boat.....so ...45ft of 1 1/2 hose , 98 ties and 3 Y valves later I have a simple system again. Guess I should have got that engineering degree !! Frank #50

[Bill]

Frank has been busy remodeling REVIVAL.  Here is his "varnishing rack" for the trim.  That piece with the holes will show up later on the maincabin side of the strongback.

[Bill]

Here is the new "self draining" anchor locker in progress . . .

[Bill]

Here is the completed look.  Note the new hatch cover.  It was shown earlier on the varnishing rack . . .  Frank says to note the storage below . . .

[frank durant]

Bill  .. I stole the anchor locker idea from the triton site. Frank #50

[c_amos]

That is a cool mod Frank.

  How much chain do you plan to carry? how much higher would you estimate that shelf would make the chain?

  I like the mod, and would think it would be a good way to 'segregate' the chain locker.  I plan to carry more chain then I really want to use on a regular basis.  Maybe the regular rode (mine is 150') with 30' or so could ride on the shelf while the remainder is laying at the ready below, with the spare anchor and other stuff that could get stand to get wet every once and a while.

[frank durant]

I carry 50ft chain and 150 rode there. I have a further 100ft chain in a bucket in the bilge (ballest) if needed. The lower erea should not get wet. The 'shelf' drains forward and overboard and is 'glassed' in . I'll let you know if it works out in practice like in theory.

[Bill]

Frank has plans for the ice box area.  "Can't belive how easy these came out . . . NOT!"

[Bill]

Frank installed a 5-Day cooler, plus 1" foil covered foam on three sides, plus two cans of spray foam.  Should be a very efficient cooler.

[Bill]

Jobe completed.  Note the 1x3x12 inch board next to companionway.  This will swing out with a CP150 chart plotter attached for viewing from the cockpit.  Frank thanks Siraccco for the idea.