Messages

I am finally realizing that I will never get this boat done and will have to let it go to a new dreamer-owner. It is a project boat the bottom has epoxy copper coat the outboard motor well has been rebuild so a Yamaha 8 hp outboard will fit. I have a new never used Yamaha outboard with remote controls that could go with with it. The balsa core in the deck has been replaced and all the opening have been sealed with epoxy. There are new knees for the chain plates  There are new cabinets built inside it needs hull and deck finish paint. I have build a custom tandem trailer that was used once. Please make an offer it has to move from where it is I will supply pictures if someone is interested. Thank You Paul

Kyle, I spotted the track on the toe rail could you tell me what kind of backup is on the inside that's how mine are but there is no backup the machine screws 1/4x20 are just tapped into epoxy when I drilled threw they are so close to the hull I can hardly get a washer on the bolt Ebb, I would like to see a picture of your pipe winch stand

I would be interested in 4 frames since 2 have cracks I have the windows out of my boat and I am certain they are cast after looking at them  again